UBI EasyCoder 101 Guide de l'utilisateur télécharger pdf (Page 45)

Chapter 4 — Troubleshooting

EasyCoder PD41 Printer User’s Guide 35

Ribbon Shield Adjustment

The ribbon shield mechanism is located on the thermal

printhead. It has two adjustable screws, A and B, as shown below.

Ribbon shield adjustment screws

If the label printout matches Test label A, turn screw A

clockwise. If the printout matches Test label B, turn screw B

clockwise. Turn the screw half a circle and perform a new test

printing. Continue until you achieve a smooth printout quality.

Screw adjustment must not exceed two full turns or paper may

not feed smoothly. In such a case, turn the screws

counterclockwise completely and start over the adjustment.

Possible printouts due to ribbon wrinkling

Clearing Media Jams

Clearing Media Jam in Print mechanism

1 Switch off the power to the printer.

2 Pull the printhead lever out and turn it counterclockwise to

lift the printhead.

3 Pull out the media from the print mechanism.

If the media has been wound up or is stuck on the platen

roller, carefully remove it by hand without using any sharp

1234567890

Test Label A

1234567890

Test Label B

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 107 108

Pas de commentaire

UBI EasyCoder 101 Guide de l'utilisateur Page 45