UBI EasyCoder 201 IIE Manuel d'instructions télécharger pdf (Page 149)

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7 147

Chapter 2 Program Instructions

LBLCOND, cont.

Remarks, cont.

IPL Mode (<nexp

> = 1):

If the print image is longer than the physical length of

the label or ticket, the print image will extend into the

following label(s) until the entire print image has been

printed. Then the media is fed out to the next gap or

mark according to the stop adjust setup. This means that

the print image will not be truncated but may extend

into one or more consecutive labels, and some of the

print image may coincide with gaps or slots.

Gap Truncate Mode (<nexp

> = 2):

If the print image is longer than the physical length

of the label or ticket, only the part of the print image

that ﬁ ts on the label or ticket will be printed and the

remainder will be ignored. This means that some of the

print image may not be printed at all, but the following

labels will not be affected.

Verifying a start adjust or stop adjust value in the Setup Mode by pressing

key No. 16 (normally labeled “Enter”), or setting the value by means

of a setup ﬁ le or setup string, will revoke any LBLCOND statement for

the parameter in question.

The label stop sensor will be returned to normal operation by the statement:

LBLCOND 2,0

All current LBLCOND statements will be revoked at startup or the execution

of a REBOOT statement. This means that the start and stop adjust will be

decided by the setup and the label stop sensor will work normally.

Example

In this example, the start adjust value in the setup mode is overridden and

the label stop sensor is set to ignore any gaps in the web within 20 mm (240

dots at 12 dots/mm) of media feed:

10 LBLCOND 1,5: LBLCOND 2,240

20 FONT "Swiss 721 BT"

30 PRTXT "Hello"

40 PRINTFEED

RUN

1 2 ... 144 145 146 147 148 149 150 151 152 153 154 ... 331 332

Pas de commentaire

UBI EasyCoder 201 IIE Manuel d'instructions Page 149