UBI EasyCoder 201 IIE Manuel d'instructions télécharger pdf (Page 280)

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7278

Chapter 2 Program Instructions

External Commands; ZMODEM

Field of Application

External commands for receiving and sending data using the ZMODEM

protocol.

Syntax RUN "rz [<switches>] [<ﬁ lename>]" (receive data)

<switches>:

-c Forces no crash recovery, even if sender requests ZCRESUM

(resume interrupted ﬁ le transfer).

-e Print last error to std OUT channel.

-l[<logﬁ le>] Send verbose output to logﬁ le. Default logﬁ le name is

"tmp:.zmodemlog".

-r If ZMCLOB is not set and the ﬁ le already exists, replace ﬁ le

if the transfer is successful.

-v[<level>] Set verbosity level. Level is a decimal number. Default

level is 1.

-u Translate ﬁ le name to uppercase. If a ﬁ lename is given as

parameter, no translation is done.

<ﬁ lename> is optionally the name under which the ﬁ le will be saved.

RUN "sz [<switches>] [<ﬁ lename>]" (send data)

<switches>:

-l[<logﬁ le>] Send verbose output to logﬁ le. Default logﬁ le name is

"tmp:.zmodemlog".

-v[<level>] Set verbosity level. Level is a decimal number. Default

level is 1.

<ﬁ lename> is the name of the ﬁ le.

Remarks

Note that rz and sz must be entered in lowercase characters.

If a ﬁ le name is given in the rz statement, this name overrides the name

given by the transmitting unit.

For more information on the ZMODEM protocol, please refer to

http://www.omen.com. Related instruction is TRANSFER ZMODEM.

1 2 ... 275 276 277 278 279 280 281 282 283 284 285 ... 331 332

Pas de commentaire

UBI EasyCoder 201 IIE Manuel d'instructions Page 280