UBI EasyCoder 201 IIE Manuel d'instructions télécharger pdf (Page 268)

Intermec Fingerprint v7.61 – Programmer’s Reference Manual Ed. 7266

Chapter 2 Program Instructions

TRANSFER ZMODEM

Field of Application

Statement for transferring data ﬁ les using ZMODEM communication

protocol.

Syntax TRANSFER

↔

Z[MODEM]<sexp

>[,<sexp

>[,sexp

>]]]

<sexp

> speciﬁ es the direction of the transmission by the expression

"S " (= send) or "R" (= receive).

<sexp

> is, optionally, the name of the ﬁ le transmitted from the printer

(default "ZMODEM.FILE").

<sexp

> speciﬁ es, optionally, the input device as "uart1:", "uart2:", or

"uart3:" (default: std IN channel).

<sexp

> speciﬁ es, optionally, the output device as "uart1:", "uart2:", or

"uart3:" (default: std OUT channel).

Remarks

ZMODEM is a protocol for serial transfer of a complete ﬁ le between

for example a PC and a printer. For more information on the ZMODEM

protocol, please refer to http://www.omen.com. Related instructions are

RZ (receive data using the ZMODEM protocol) and SZ (send data using

the ZMODEM protocol).

TRANSFER ZMODEM can only handle one single ﬁ le at a time.

When transmitting ﬁ les from the printer to the host, carefully observe

possible restrictions concerning the number of characters etc. in the ﬁ le name,

that is imposed by the operating system of the host.

When receiving a ﬁ le, you must start the transmission within 30 seconds

from completing the TRANSFER ZMODEM "R" statement. The printer

will store the ﬁ le in the current directory "c:", "tmp:", or "card1:", see

CHDIR statement. (Obviously, ﬁ les cannot be received into "rom:".) If there

already exists a ﬁ le in the current directory with the same name as the one

to be transferred, the existing ﬁ le will be replaced by the new ﬁ le. Thus, it is

up to you to keep record of the ﬁ les already stored in the current directory

(see FILES statement). Before transfer, give the new ﬁ le a name that is not

already occupied by an existing ﬁ le, unless you want to replace the existing

ﬁ le. If you use TRANSFER ZMODEM to download a font or image ﬁ le,

the font or image will automatically be installed after the downloading is

completed without any need for a reboot.

Examples

Setting up the printer for ﬁ le reception on the standard IN channel:

TRANSFER ZMODEM "R"

Transmission from printer to host of the ﬁ le "FILE1.TXT" on a channel

other than the standard OUT channel:

TRANSFER Z "S","FILE1.TXT","uart2:","uart2:"

1 2 ... 263 264 265 266 267 268 269 270 271 272 273 ... 331 332

Commentaires sur ces manuels

Pas de commentaire

UBI EasyCoder 201 IIE Manuel d'instructions Page 268

Commentaires sur ces manuels

Produits connexes et manuels pour Imprimantes d'étiquettes UBI EasyCoder 201 IIE