UBI EasyCoder 201 II Spécifications télécharger pdf (Page 106)

Chapter 7— IPL Command Reference

90 IPL Programmer’s Reference Manual

Print Commands

You can use Print commands to pass data to formats and print labels.

When you enter data into a format for printing, the printer uses a field

pointer to designate the field in the format where the data should print. If

you choose a new format, the field pointer automatically points to the

lowest numbered data entry field and continues to point to that field until

you select a different field or format. If you select a field by using the

<CR> or <ESC>F command, new data entered into the field overwrites

any data already existing in the field.

Print commands are effective when the printer is in Print mode. You can

switch to Print mode with this command:

For help downloading Print commands to the printer, see “Sending IPL

Commands to the Printer” in Chapter 1.

Note: You must precede each string of commands with the start of

message character <STX> and follow it with the end of message character

<ETX>. The next command in the message terminates all Print mode

commands. The command separator (<NUL> or <LF>) is optional

between commands, but is necessary to separate commands from data. For

example, to separate the <ESC>F command from data, type:

<ESC>F4<NUL>data

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 269 270

Pas de commentaire

UBI EasyCoder 201 II Spécifications Page 106