UBI EasyCoder 201 II Spécifications télécharger pdf (Page 259)

Appendix E— Using Direct Graphics Mode

IPL Programmer’s Reference Manual 243

Change Origin

Purpose: Tells the printer the X and Y coordinates of the next RLE data column.

Default: 0,0

Syntax: 0x21[x,y]

where x and y are the coordinates of the next data column. Values for x

and y range from 0 to 8191.

The change origin command tells the printer where to place the graphic on

the label. If you do not send the command, the printer uses the default

setting of 0,0.

You can use the command to place different sections of the RLE graphic in

different parts of the label.

Notes: It is not necessary to use this command for every column. Column-to-

column transitions are automatic following the end of line command.

The default origin of any direct graphic (0,0) is in the lower left corner

instead of in the upper left corner. The upper left corner is the label format

origin.

End of Bitmap

Purpose: Marks the end of RLE encoded data.

Syntax: 0x28

Notes: The printer parses subsequent characters as IPL commands.

On the final column of the RLE encoded data, an end of line command

does not need to precede the end of bitmap command.

End of Line

Purpose: Causes the printer to assign subsequent bitmap data to the next column.

Syntax: 0x22

Notes: The printer images the next data stream in the next column position,

incrementing the X position. This command causes an action similar in

function to a carriage return.

1 2 ... 254 255 256 257 258 259 260 261 262 263 264 ... 269 270

Pas de commentaire

UBI EasyCoder 201 II Spécifications Page 259